HOME COMPANY PRODUCTS SERVICES REQUEST QUOTE CONTACT US
Product Categories
Products / Chip Handling (Chip Plant)

Single Speed CPM 7000 Pellet Mill
Product Number: 5920
This mill uses a standard 700 die #AD226 and roller assembly #ARS191. Die is 22.5" ID x 6-1/8 wide face

- Reconditioned gear box and base
- Oil filter system (new oil pump & external motor)
- Air oil cooler c/w controller, TEFC, 575 volt
- All new bearings
- All new seals
- All new gaskets
- New quill shaft assembly
- New main shaft assembly c/w disc
- New Dunlop main shaft seal c/w new seal cups
- New deflector and wipers
- New pinion shaft with cartridge
- New main gear
- Roller adj gears
- New front roller support assembly
- New 3 piece die clamp assembly
- 2 new ARS 191 closed end roller assembly
- Feed cone
- New feed cone bolt assembly
- New gear box liner
- New SS door c/w knives & manual dump chute left hand hinged
- 10 extra shear pins
- Filled with oil and test run
- No main drive motor / coupling or guard supplied

Optional additions

Option 1 - New ARS191 - 700 closed end roller assemblies

Option 2
- New feeder and conditioner 18 LL x 8.5 c/w die hoist
Feeder
- 18" diameter x 104" SS barrel c/w 3 bolted access doors (on RH or LH)
- Mild steel end plates with SS liners
- 2 liquid addition ports on top at inlet end
- Stainless steel conditioner shaft
- SS adj pics with hard faced ends
- SS inlet pic array
- Motor mount on LH or RH side
- Steam thermometer mounted in discharge end
- 4" dia steam inlet (on RH or LH side)
- LL type steam inlet
- Std 4 bolt ecc lock bearings
- 8 groove sheaves c/w new belts and guards
- 20 HP TEFC 575 volt, 1200 RPM drive motor
Conditioner
- 12" dia SS feeder screw c/w drive and tail shaft
- SS 12" feeder trough
- SS trough lid bolted down
- Mild steel end plates with SS liners
- New bearings and seals
- Discharge to fit conditioner inlet
- Hinged and clamped magnet in feeder discharge throat
- VFD inline TEFC 575 volt, 2 HP drive motor and gear box
- Drive to be mounted on feeder inlet end on LH or RH side
- VFD controller 575 volt
- #60 chain, sprockets and guards
Die Hoist
- Manual die hoist to fit over 7000 mill and under 18LL8.5
- With manual winch, cable and hoist trolley
- Die and roll lifting plates included
- Entire unit to be painted CPM green

Option 3
- 200 HP, TEFC, 575 volt, 1800 RPM main drive motor
- with coupling and guard
- HH1200-18-575-447TBB, TEFC